VI STA SERI ES VI S T A- 50P / VI S T A- 50P U L Commercial Burglary Partitioned Security System With Scheduling Installation and Setup Guide N5944-6V2 5/04 Rev B ii Table of Contents • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • List of Figures................. V Conventions Used in This Manual............. Vi SECTION 1: General Description............. 1-1 About the VISTA-50P/VISTA-50PUL................1-1 Features......................1-1 Theory of Partitioning...................2-1 Setting-Up a Partitioned System.................2-1 Common Lobby Logic...................2-1 Master Keypad Setup and Operation................2-3 SECTION 2: Partitioning............... View and Download Honeywell VISTA-15PSIA installation and setup manual online. Honeywell VISTA-20P/VISTA-20PSIA/VISTA-15P/VISTA-15PSIA Security Systems Installation and Setup Guide. 2-1 SECTION 3: Installing the Control............. ADEMCO 6160RF Keypad/Transceiver K0903V1 2/06 Rev. B Installation and Setup Guide GENERAL INFORMATION The ADEMCO 6160RF keypad/transceiver is a combination unit that combines the functions of the following devices: • 6160 Alphanumeric Addressable Keypad • 5881H RF Receiver • 5800TM Transmitter Module The 6160RF Keypad/Transceiver may be used on any control panel that supports 5800 Series wireless devices (e.g., VISTA-10P, VISTA-15P, VISTA-20P). FEATURES • Supports wireless key transmitters (e.g.; 5804) and bi-directional transmitters (e.g.; 5804BD, 5828/5828V). • Supports wireless keys with high-security (encryption) capability (e.g.; 5804E). • Provides a nominal range of 200 feet' for RF transmitters (some transmitters have a shorter range). • Supports RF jam detection when the receiver is enabled. • Capable of sending status signals (Armed, Ready, etc.) to bi-directional units such as 5804BD, 5804BDV and 5828/5828V. UL The following 5800 series transmitters are not intended for use in UL installations: 5802, 5804, 5804BD, 5804BDV, 5804E, 5814, 5816TEMP, 5819, 5819BRS, 5819WHS, 5828/5828V and 5850. Pass the wiring from the control panel through INSTALLING THE 6160RF Locate the 6160RF in an area and at a height where it is convenient for user operation. The 6160RF must be at least 10 ft from the control panel to ensure proper operation of the RF receiver. Mounting and Wiring the opening in the case back. (see the control panel’s instructions for proper run lengths.) a. If surface wiring is being used, wiring may be routed through the top or the bottom left-side breakout in the case back. The breakouts must be punched out using a screwdriver before mounting the case back. If desired, wires may be strain-relieved to the wire tie point on the inside of the case back with a tie wrap (not supplied). Mount the case back to a wall or to an electrical box using the 25mm-long self-tapping screws supplied (mollies for drywall are not supplied). Connect the power and data wires from the control panel to the terminals on the 6160RF as indicated in Figure 2 and Table 1. The 6160RF has terminal blocks for connection to power and data wires. Removing the keypad’s case back provides access to the terminal blocks.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2019
Categories |